The BlueStar communicates via a low-power, 2.4-gigahertz radio link called Bluetooth, a protocol invented to allow electronic devices to talk to each other over a short distance (see for all the techy details). And now, thanks to the BlueStar, this can happen without any worry of a connecting cable wrapping around the spinning scope. Click on an object anywhere on the star chart, and off the scope goes to find it. You typically see a star chart showing where in the sky your scope is pointed and what other objects of interest might be nearby. ![]() Operating a telescope with planetarium software on a computer, rather than the telescope's hand controller, gives you more information. It allows a computer to control a Go To telescope through a wireless connection. And the Starry Night BlueStar Telescope Adapter from Orion Telescopes & Binoculars promises to do just that. I don't know how it happens, but I think it's evidence that string theory must be correct.Īs far as I'm concerned, anything that eliminates wires and cables at the telescope is a technological advance of the highest order. A corollary is that even one wire will get tangled with itself. The entanglement principle is truer if it is dark. THERE'S A LAW of the universe that says two wires anywhere near each other will get tangled. APA style: The Starry Night BlueStar Telescope Adapter: this nifty device allows you to control a go to telescope with a computer via a wireless connection.No annoying cables to tangle." Retrieved from The Starry Night BlueStar Telescope Adapter: this nifty device allows you to control a go to telescope with a computer via a wireless connection. No annoying cables to tangle." The Free Library. ![]() MLA style: "The Starry Night BlueStar Telescope Adapter: this nifty device allows you to control a go to telescope with a computer via a wireless connection.Both MaximDL and Starry Night should now have combined access to the mount and will freely share data from the mount and both will be able to control it - incredibly handy too!ĭoing this will confirm at all times that the mount is working using ASCOM/EQMod so you will be able to fault-find Starry Night more easily. ![]() Now see if MaximDL will control the mount.Īssuming that all is well with MaximDL, turn to Starry Night and configure it using the ASCOM option to also point to 'POTH'. Now configure POTH to use the EQMod driver (Options - Setup - Choose 'Scope). Next, go to Maxim DL and select the telescope control panel and choose 'POTH' as your telescope. This also works with the EQMod Simulator if that doesn't appear in the ASCOM chooser drop down. Go to the directory that stores the EQMod downloads and double click on EQMOD.EXE This will come up with an error message stating that it is an ASCOM driver and cannot be run 'standalone' ! This is quite rue but for some reason this procedure registers the EQMod driver with ASCOM beautifully. From what I can see, you are using EQMod so there is NO need for you to have the Celestron drivers in place at all as you will be connecting to the 'scope via ASCOM and the ASCOM EQMod driver. I am a little confused by one aspect of this.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |